DIY - Super Simple Lightsphere - replica of Gary Fong Lightsphere

Hope this might interest all bros ya~

It is very easy since the material was easily acquire from your daily lunch or dinner 's container 

This is the - Lightsphere 
Gary Fong Lightsphere RM120 above Vs. My Lightsphere RM3 below  ..kakaka

.

when it was in full force~!!!

.

.

Now let's see how to do it ya~
1 - get the plastic container at this size or bigger size, pen knife, marker pen, Cella tape, paper(best is printer paper- thin) and rubber wrist band(as holder for d flash)
2 - use marker pen and ruler to mark some guideline on the bottom of this container
3 - patiently use pen knife to cut off the bottom
4 - use cella tape to tape the edge of the opening so it will smooth out the sharpness and serve as cushioning when you insert your flash.
5 - lastly, cut the printer paper n use cella tape to tape it one the cover. coz if the paper size is just rite, you won't be able to close it. Stick it is the best

.

.

.

.

use the rubber wrist band to control slips
****now DO YOU NOTICE that it was clear inside, when flash was not fire???

.

. 

***Now low level flash was fired

  .

.

.

***Now high level flash was fired

.

.

more for reference

  .

.

.

.

oK, now lets see how it performs ya~


the 2 pics below were taken while room lights ON
.
1st with direct flash - harsh

.
.

2nd with Lightsphere - soft n with details

 .
.
now with room lights OFF
1st with direct flash - lights power saturated

.
.
2nd with Lightsphere - lights was well delivered/distributed

.
.
### Now skin tone

1st with direct flash - yellowish skin

  .
.
2nd with Lightsphere - well WB skin tone, since my skin was fair one
 

.

.

. 
thanks for viewing ~
hope you will like this simple Lightsphere ya~
.
.
.